Abstract:PPR pipe is a product that is frequently used in our daily life, and it is an important load-bearing object of water flow. So how can the leakage of P...
PPR pipe is a product that is frequently used in our daily life, and it is an important load-bearing object of water flow. So how can the leakage of PPR pipe be quickly filled?
1. You can apply the plugging king on the leaking area.
2. Close the water valve, find the leaking area, drain the remaining water in the pipeline, use a saw to cut off the leaked area, sand the sawed area with sandpaper, take a new PPR pipe, and weld it together with a hot melt gun.
PPR water pipe installation and matters needing attention
1. Remember to check and accept the water pipe after entering the site
For the construction of this type of product, you must pay attention to the acceptance before entering the site to see whether the quality of the product meets the relevant requirements and whether there is an anti-counterfeiting mark on the pipe.
2. Pay attention to the hot melt problem of water pipes
We also need to pay attention to the fusion of the pipe. Generally speaking, the temperature of the pipe should be controlled at 250 degrees as much as possible, and the pipe must be taken over within 7 seconds after the fusion. The speed should be fast and the residence time should not be too long, otherwise it will seriously affect the contact between the pipes. In addition, pay attention to flat insertion and do not twist and rotate forcefully.
3. Tighten the nozzle of the water pipe
Although water pipe installation is not a complicated matter, if it is not tightened, water leakage is prone to occur later. Therefore, when connecting, the nozzle must be tightened and cannot be loosened. In addition, the valve should be installed in the home to increase the comfort of the product.
www.inverter-factory.com 
英语
